Effect of annealing temperature on microstructure and performance of high purity Al-1wt% Si alloy 退火温度对高纯Al-1wt%Si合金组织及性能的影响
Effects of Annealing Temperature on Microstructure and Mechanical Properties of High Nb-IF Steel With Strength Level of 440 MPa 退火温度对440MPa级高铌IF钢显微组织和力学性能的影响
Effect of Annealing Temperature on Optical Absorption Properties of Au/ NiO Nano-Composite Thin Film 退火温度对Au/NiO纳米颗粒复合薄膜光吸收性能的影响
Effect of Annealing Temperature on Texture of Nb+ Ti Stabilized Ferritic Stainless Steel 退火温度对Nb+Ti双稳铁素体不锈钢织构的影响
Effect of annealing temperature on structure and gas-sensing properties of WO_3 thin films 退火温度对WO3薄膜结构及气敏性能的影响
Differences of RT-PCR amplificates at different annealing temperature showed that higher annealing temperature ( 60 ℃) was helpful to specific amplification. RT-PCR反应中不同退火温度的比较显示,较高的退火温度(60℃)有助于特异性扩增。
Influence of Annealing Temperature on Structure and Ferroelectric Properties of BiFeO_3 Thin Films Prepared by Sol-gel Process 退火温度对Sol-gel法制备的BiFeO3薄膜结构及电性能的影响
The Effect of Annealing Temperature on the Properties and Second-Phase Particles of 0.4 mm Galvanized Ti-IF Steel 退火温度对0.4mm热镀锌Ti-IF钢板组织和性能的影响
Effect of Annealing Temperature on the Magnetic Properties and Structures of [ BN/ CoPt]_n/ Ag Thin Films 退火温度对[BN/CoPt]n/Ag薄膜磁性和结构的影响
Effect of Annealing Temperature on Structure and Optical Properties of ZnO Nanorods 退火温度对ZnO纳米棒结构和光学性能的影响
Influence of Annealing Temperature on the Structure and Photoluminescence Properties of Continuous Freestanding SiC Films in Air 空气环境下退火温度对连续SiC自由膜结构与发光特性的影响
Therefore, the hot-rolled sheet annealing temperature should be as low as possible with the precondition of fully recrystallization. 所以,在保证热轧板发生完全再结晶的前提下,退火温度应尽量低。
The results show that the annealing temperature is an important factor to affect the formability of final sheet. 研究结果表明,热轧板的退火温度是影响成形性能的重要因素。
The effect of annealing temperature on micro-orientation in cross shear rolled high purity aluminum foils was investigated by means of orientation distribution functions ( ODFs). 通过异步轧制,对高纯铝箔微取向流变行为进行了研究,结果表明:异步轧制与同步轧制的冷轧织构有较大差异。
When the annealing temperature has been reached, the steel should be held there until it is uniform throughout. 达到退火温度后,钢应当保持在此温度等到全部均匀受热。
Influence of Continuous Annealing Temperature on Microstructure and Properties of 780 MPa Cold Rolled Dual Phase Steel 不同退火温度对冷轧780MPa级双相钢组织性能的影响
Under controlled conditions the oven slowly and evenly heats the glass to annealing temperature. 在受控条件下炉缓慢均匀加热玻璃的退火温度。
The extent of crystallization increased with the annealing temperature. 晶化程度随退火温度升高。
The Optimum Annealing Temperature of SRAP-PCR on Pumpkin and the Analysis of Genetic Diversity 西葫芦SRAP-PCR退火温度的优化及遗传多样性分析
Analysis on the microstructure shows that precipitation of compound containing titanium was found in the steel, and its amount increases with the elevation of annealing temperature. 显微组织分析表明,含钛钢中生成了钛化物相,并且随着退火温度的提高,钛化物析出量增多。
The effects of hot-dip galvanizing annealing temperature on microstructure and mechanical properties of DP780 were investigated. 主要研究了热镀锌退火温度对DP780的组织和性能的影响。
The different mechanical properties and plasticity of workpiece were obtained through adjusting annealing temperature. 对旋压工件采用不同温度的退火,得到不同的力学性能和塑性指标。
The different recrystallization annealing temperature and the micro-hardness of sample show the complex relationship. 不同的再结晶退火温度与试样的显微硬度表现出复杂关系。
In addition, both hydrogen permeation time and trapping coefficient of hydrogen increase but the hydrogen diffusivity decreases in the steel with the elevation of annealing temperature. 此外,随着退火温度的提高,氢渗透时间和氢陷阱系数也增大,而氢的扩散系数则降低。
Effect of Annealing Temperature on the Structure of Ge Nanocrystals Embedded in SiO_2 Film 退火温度对镶嵌于SiO2膜中的Ge纳米晶结构的影响
Influence of Annealing Temperature on Infrared Transmittance of VO_2 Film 退火温度对二氧化钒薄膜红外透过率的影响
Effect of Pressure and Annealing Temperature on Structure of SiC Thin Films 工作压强和退火温度对SiC薄膜结构的影响
Effect of Annealing Temperature on Microstructure and Tensile Properties of Ti_3Al Alloy Hot-Rolled Sheets 退火温度对Ti3Al合金热轧板材微观组织和室温拉伸性能的影响
With increasing the annealing temperature, the crystal structure changes from anatase to rutile and the crystallite size increases. 随着热处理温度升高,晶体结构由锐钛矿晶相向金红石晶相转化,同时微晶的颗粒尺寸增加。
The effect of finishing rolling ratio, softening annealing temperature and grain size on the4004/ 3003/ 4004 aluminum alloy brazing foil is studied in this paper. 研究了4004/3003/4004钎焊用铝合金箔材的成品轧制率、软化退火温度以及晶粒尺寸时其抗下垂性能的影响。